1. Automatic tire centering system
2.Automatic correction of the buffing profile to compensate any tire offset .Through three-axis servo motor linkage, achieve special curve grinding,grinding precision automatically.
3.Automatic detection of the rest rubber thickness & buffing-tire perimeter.To ensure stable grinding process.
Standard process requirements--
·The rest rubber thickness:2-2.5mm；
·The two shoulders circumference different ≤6mm.
4.With sidewall cleanning device controlled by servo motor for grinding sidewall with different size.
5.Gradle type lift to facilitate tire loading/unloading from the monorail system.
6.Blade cooling device reduces granding temperature and reduces blade wear.
7.The protection devices for safety protection.
8.Self diagnostic and troubles-shooting system.Remote diagnosis and debugging can be achieved.
1. Exhaust and dust removal system
2. Taper and needle-nosed pliers (cut the leaking wire)
3. Tire marking chalk (mark the location of the wound, tread width, etc.)
4. Lubricating agent of expansion wheel (apply regularly)
5. Tire parameter table (input PC configuration table in advance, and call it out directly when polishing)
6. Tread base measuring ruler/pattern depth meter/flexible tape measure (can be used for phased detection)
7. RMA standard grinding roughness template (used to judge the wear of grinding tool head)
8. Goggles with side protection
9、Safety shoes
1. Compressed air pressure: 5 ~ 8kg/cm
2.Tire inflation pressure: 1.5kg /cm2.
1. after grinding the tire, the grinding surface should be maintained with a 1.5~2.5mm rubber layer.
2.After grinding , tire body line area for one place may not be greater than 1% of the area of the tyre abrasion；
Total out-line area shall not be greater than 2%, polishing line depth does not hurt cord fabric layer.
3.after grinding ,tire puncture holes and other defects of each tire shall not exceed 3, and the distance between the two wounds shall not be less than 1/6 of the tire circumference.
4. Grinding requirements:
4.1 grinding depth shall be controlled at 1.5-2mm.Rough finish of polished surface :RMA 3 ~ 5.
4.2 grinding surface deviation, tire crown grinding surface deviation is not greater than 1MM °
4.3 the width of the polished crown shall be equal to or less than 1/16 inch (2mm) of the base width of the tread, and the tread dimensions used shall be in accordance with the tire parameters (the grinding radius of the machine shall be set in accordance with the tire parameters).
1.Before buffing， eliminate the visible foreign matter, including stone, nails, screws, etc.
2.inflatable no more than 15 psi (1.5 Kg/cm2).
3. labor protection glasses
4. not allowed to wear gloves and wear comfortable clothes
5.long hair must be bandaged up
Please refer to the manual grinding machine equipment, understand any security problems.
1. Safe production;
2. process standardization, efficiency maximization, production of fine Retreading tires.