Commercial Vehicle Guide Wheels Intelligent Tire Pressure Monitoring System
Safe, Fuel - efficient, Wear - resistant and Comfortable
1.Select a 7cm×7cm area inside the tire near the tire number, polish it thoroughly with a grinder, then wipe it off with a clean paper towel or cloth.
2.Apply a bit of glue to the rubber case of the sensor that combines the press tool. Apply evenly with a plastic spatula.
3.Hold the sensor with the pressing tool in the cleaning area for about 30 seconds (note the mounting direction shown).
4.Remove the press tool and paste the bar code on both sides of the tire
6.After all the tires have been installed for about 20 minutes, gently shake the sensor with your hand to see if it is stuck.
5.Repeat the steps above to install the remaining tires.
7.The installation is complete
1.Scan the QR code to download and install the smart tire APP
2.Open the smart APP and allow the location and bluetooth to open. Please keep the bluetooth open during use
3.Open the [my] page and click "Settings" to set the initial alarm threshold (standard air pressure ±25% is recommended). After setting, open the [binding] page for binding.
4.Open the "binding" page, click "scan" in the upper right corner to scan the sensor barcode pasted on the smart tire, and bind the corresponding wheel bit.
5.Open the "monitoring" page and monitor the tire status
6.If an alarm occurs, the monitoring page will turn red with alarm sound and vibration. The user can click the [horn] button in the upper right corner of the monitoring page to cancel the alarm prompt
7.If you need to rebind, please return to the "Settings" page and click "clear data". After clearing data, you can rebind